I ordered this enclosure fully expecting to have to cut the top protective panel off from it, nope, it is completely an included option, not connected from the factory- but can be very easily installed if needed.Next thing I found out was the door can be removed and flipped to swing the opposite direction, which I needed, in just 5 minutes I had the outermost "e-clip" removed from each of the hinge pins, removed the pins, removed the hinges from the factory installed right side- to the left, as my need required.I will need to make 2 unusually large openings in the top (reason for not needing the rain guard) and left side walls for easy mounting of 2 very large heat sinks capable of cooling 4 SSR's without an additional electrical circuit for a fan, and no need for holes in the cabinet case for air vents, which would allow dust to enter the case. This case will be completely sealed when I'm done.I want looking for a removable mounting plate inside, so there is another benefit to this enclosure.The page mentions the enclosure to door grounding wire is previously installed, but it was not, on mine, another benefit, since I had to remove the door to flip it anyway.The only thing I found that I do not like, is that grounding wire is just short enough, with the terminals supplied, to make me cautious of how I installed it, compared to how it will flex, bend, and twist, and potentially wear the wire prematurely.Bonus, the vevor name decal on the door is very easily removable, mine would have been upside-down, after the door flip.Time to start component layout and assembly, for this to become the control panel for my home fabricated powdercoat oven...I'll add photos or video later...I'm definitely giving this enclosure a 5 star rating, it definitely exceeded my needs AND expectations.
C.R. 
