Took about 45 minutes to put together with a couple mistakes made along the way. The drawers feel better than I thought they would. They can fit smaller reels of wire but, not the big ones. Does fit my stick welding lead in one of the drawers so I always have that with. Only issue is that the Lincoln 210 MP kinda fits in the welder area but, it would’ve been a pain to open the side door without sliding the welder up and back so, I set it on a couple chunks of a pallet and strapped it down to make sure it can’t fall off. The entire cart is a little shorter than I expected. I’m 6 foot 2 and have to bend over to grab the handle to move the thing around. I don’t make a living welding, I just do heavy diesel repairs and whatnot outa my garage so, it’ll get used maybe a couple times a month. Not super often so, I doubt I’ll have any durability issues for quite some time. I don’t think I’d get this for heavy daily use, it is sturdy but, the metal could be heavier duty. The front spinning casters don’t seem great but, neither is my garage floor. I greased all the drawer bearings and casters during assembly. Drawers feel surprisingly good. They are ball bearing drawers. Pretty cheap looking ball bearing setup but, ball bearing none the less. I’ll update if I have any major issues.
Michael Morrison 
