VEVOR Set of 8 Flow Matched Fuel Injectors 80lb EV1 Fuel Injectors High Impedance OEM Injectors for Ford GM V8 LT1 LS1 LS6 835cc 110324 FI114992

These injectors flow 80 lbs/hr at 43.5 PSI ( 3 BAR ) and up to 100 lbs/hr at 80 PSI. Despite the high flow rate these units are high-impedance, plus they are linear and controllable at low pulse widths and have been used in ULEV applications! This allows you to use a larger injector than normally possible without hurting idle and low speed drive-ability. Adding to the flexibility of application, these units are high-impedance; making them compatible with most ECUs, while delivering the most flow available in a High-Impedance injector.

These injectors are able to function at high fuel pressures and don’t exhibit the high fuel pressure handling problems found with many other high flow high-impedance injectors. This makes these injectors very well suited to turbocharged and supercharged applications that see high fuel system pressures.

Applications

These High Impedance(Approx. 12 OHMS) Saturated injectors will fit all of the following models:

The following models must change injector plugs

The following models require spacers and longer fuel rail bolts and must change injector plugs

Note

• These high performance injectors will require ECU tuning.
• Injector clips may be required for some models.
• Verify flow rate is correct for your car application.

• Quantity: One set of 8 fuel injectors
• Cross references:  FI114992/110324
• Car make: For Chrysler, GM, BMW, VW, Audi, Mitsubishi, etc
• Design: GEN III EV1 style fuel injector
• O-rings included: Yes, preinstalled
• Injector design: Metal & composite plastic
• Orifice type: 1 hole
• Connector: EV1
• Filter design: Basket filter design at inlet
• Fuel delivery: Single nozzle cone shape
• Spray pattern: 15 degree spray cone
• O-ring type: Viton
  

• Dynamic flow rate : 18.6 mg/pulse 2.5ms PW, 20 ms Period
• Coil resistance: 12 Ohms (This high-impedance injector will work with all factory ECM/PCM injector drivers)
• Static flow rate: 80 lb/hr = 835 cc/min at  43.5PSI ( 300kPa )
• Gain: 0.12ms/MG
• Offset: 0.055ms
• Turn on time 1.14ms at 14VDC
• Turn off time: 0.85ms at 600KPa
• Voltage: 8-15 Volts, nominal 13.5 Volts
• Amperage: 1.0 Amps
• Pressure: Min 30PSIG/ Max 100PSIG
• Variance: 2 %
• Overall length: 2 7/8 inches, 74 mm
• O-ring to O-ring length: 2 1/2 inches, 63 mm
• Diameter: 16 mm
• O-rings: Top and bottom 14.5 mm
• Packing size: 5X4X3inch/12X9X6cm
• G.W.: 4lbs/1.5kg