VEVOR Tile Shower Seat, 47.2" x 16" x 20" Ready to Tile Shower Seat, Factory Waterproof & 100% Leak Proof Tileable Shower Corner Seat, 440lbs Load-Bearing Rectangular Board Shower Bench, Grey

Made setting up a bench in our new shower a breeze for our contractor. He said it was super easy to work with, and it looked amazing once tiled over!

Nice product. Easy installation. Very fair price. I will definitely be using this product again.

The product worked well. I had to cut it down to fit. My application and worried about that. But it worked fine. The material was then a bit loose but the thin set layer down on it and adhered well.

This worked great for my shower bench. Cheaper then name brands with the same install and results

Undated bathroom without having to redo all the tile. This is great

Great Bench for foam shower installs.I'm a 16 year tile installer. We have used every brand on the market for our shower installs. We always gravitate to the Wedi system as it's the best. Schluter is ok but the foam is softer and there's a lot of steps to achieve the same outcome. The only issue I have is that wedi didn't offer a box bench like this. Schluter does but they want too much for it. So I took a chance with this brand and I have to say it worked out great. It's definitely not the most durable or hard foam but it's good enough to buy again in the future. It installed easily, it cuts easily, and it looks good wedi installs.My biggest complaint if you call it that....is when you cut the foam it's like a bunch of little balls and they go everywhere and cling to everything. I wish they would use a slightly denser foam and maby offer some extra fabric and sealant for when you have to cut the bench to make it fit. Which is why I give 4 stars. All in all it's about the same quality as the kerdi/Schluter bench.During the insall I had to cut off about 4" from one of the ends. After I cut it off i spread a layer of wedi sealant all over the cut off area and covered it with wedi dry liner fabric. Then added wedi subliner tape to the edges and corners for added protection. This was probably over kill but I'd rather be safe than sorry.Next I skimmed the bottom of the bench with thinset and attached it to the floor using a half inch euro V notched trowel and used Ardex x77 thinset. Then I skimmed the bench end with wedi sealant where it attaches to the wall and added a lot of wedi sealant to the wall where it attached to the wedi board. Press in place level it out and slightly pitch it toward the drain and locked it in place until the next day. Everything worked great. It's solid and I would need a sledge hammer to remove it if I had to.I will definitely be buying again in the future. Great price, great product, and worth the purchase. Don't hesitate. It's as good as th

This was a last minute purchase in the middle of a remodel. I am so thankful we committed to adding this feature to our shower because it looks great!

Easy install instructions. Great corner bench installed in new shower build.