Received the bender, and mounted it on a 2 x 6, lag bolted into the studs in the garage.I set-about a project that I had been postponing until this purchase arrived, and found it to be a solution to several different problems which I needed to solve.It is sturdy, and appears to be fit for long term, heavy duty use.NOTE: The photographs of this bender show the bender with the exchangeable radius forms installed upside-down. The square/rectangular protrusion in the casting is the stop which prevents the radius form from rotating. If used with the radius form installed as shown in the photos, you risk breaking a radius form when bending under extreme conditions,Additionally, you may find that you have to use some sand paper to remove the paint from the radius form pivot holes, before they will fit easily on the bender hub. A minute or two, with a piece of rolled-up 320 grit sand paper will do it for you, though--nothing to write home about.All-in-all, this will get quite a bit of use in the future days and months ahead.
andy 
