Customer Reviews for VEVOR 16 Ton Exhaust Tubing Bender 1/2 Inch Square Hydraulic Hand Pump Tubing Bender Stroke 130mm Pipe Bending Tool Steel Pipe Bender with 8 Dies

If you want a good laugh, check out the instructions in the attached photo! Really? These are close to the worst I have seen.There is a design flaw in this in that the pipe achor (hole that the pipe runs through) is too far away from the mandrel so the first 40 degrees or so of the bend actually come out uncurved and straight. I couldn't figure out a workaround for that problem.

This product is fairly straight forward and simple to set up and use. I see many future uses at the Boat Yard.

Great quality tool. Came in good, sturdy shipping as well.

Recommended for small tubes . Ease of use and setup is a breeze I am very satisfied with my purchase from Vevor delivery went good and on time. Still using it will give another review as I build go kart and mini bike frames.

Muy bueno lo recomiendo

The bender works great. The only issue i had was the jigs are set for a certain diameter for the inside of the pipe not the outside of the pipe. The pipe I needed to bend was considered 1” diameter but the actual diameter of the outside pipe was 1 1/4” and the pipe would not fit in the bender jig. My 3/4” pipe fit perfect on the 1” bender.

Very easy to use and good quality, The price was also very reasonable The multiple die sets make for a variety of uses on many projects

The casting and machining is typical of foreign craftsmanship, but produced pretty smooth bends in 3/8” copper/nickel. Well worth the money, but not finess

Worked as well as bender of this caliber could be expected to. Anything that could work better with the same thickness material is probably 5 times as expensive.

Great tool I'm very happy with it thanks a lot