Customer Reviews for VEVOR Chimney Sweep Kit 30FT Length, Chimney Brush Kit with 9 Nylon Flexible Rods, Rotary Chimney Cleaning Kit Driven by Drill, Chimney Cleaning Tool Kits for Sweeping Fireplace Flue

Made cleaning my chimney very easy and cleaned better and faster than expected. I was impressed by to flexibility of rods, I have a tight 90 degree corner at my clean out but went In and had no problem at all. I was happy to be able to chimney sweep from the bottom and be able to stay off my steep 2 story roof. I was very impressed.

This thing is awesome. Works great on the chimney

Easy to use, assemble and worked perfect.

Have used these multiple times over last few years, with a 12-volt portable drill. All together the system works quite well. My only complaint is that the sections can be somewhat difficult to disassemble, and the one section that goes into the drill chuck looks like all the others, so sometimes it has to be removed to place it correctly at the end of the run of rods.

I have a 90 degree bend about 24 inches into the wall pipe. This set went right around the bend. I wasn’t able to clean my chimney without going on the roof before so I was always at the mercy of the weather. I live in PA and we always get snow so I had to wait till a warmer day so the snow melted off of the roof. This is a game changer for me. I can now clean my chimney in a blizzard in the safety of my basement.Downside is this is a little messy. I put a big funnel over the pipe and stuck the rod through it to cut down on the black dust coming out. This kit is well worth the money and the mess isn’t the cleaning kits fault it is just part of burning a wood burner.

Used once so far, did well as far as we can see. I like using this from the bottom and working it up to the top.Beats standing on the roof and using the old method. Hope to keep using this 2-3 times per heating season.

Cleaned chimney great

Apart from the minor difficulty in unfastening the sections from one another this is great. Flexible enough to do the job from the inside. It's a somewhat dirty job but that's par for the course in owning a wood stove. I would buy this again no hesitation.

This works well, but use at very low speeds. We have a concrete/brick chimney and anything above the very lowest setting on my drill resulted in bits of broken brick falling. So be patient and take your time and you should get the job done without any issue.

It worked very well for me. I used a drill. No problems with it staying together or coming apart while using