Customer Reviews for VEVOR 50Amp Non-Touch Pilot Arc Plasma Cutter, 110/220V Dual Voltage Plasma Cutting Machine, Max 1/2 Inch(14MM) Clean Cut, Portable Cutting Machine IGBT Inverter Digital Plasma Cutting Equipment

Can't get it to work with langmuire table. Hf start interferes with the electronics. Is there a way to change it to blowback start

he loves it he uses it more than anything now for every that deal with cutting metal wise

Everything came as expected. 110VAC/220VAC a little confusing as it came with 110VAC plug only so not sure how to how up to 220VAC?

Unit arrived on time and undamaged. Cutting a lot of 1/4" plate on 220volts and it does a nice job in the hands of this novice. It runs fine on 30A breakers. Some have commented about the ground clamp. I've had no issues with the clamp but the cable pulled out of the male connector on the other end. Set screw was tight but it didn't capture the cable well. I put a 6ga sleeve inside a 4ga sleeve and reinserted the cable. Now the set screw tightly grips the cable. Do not expect any further issues.

It works like expected. It is a great asset to my home shop. I recommened this plasma cutter to other home DIYers. My only concern was there was no expert that could answer my questions about an adequate plug for 220V.

So far so good. I have cut a little bit of 1/2 inch stock without issue. Cots through lighter material like butter. Easy set up and operation.

Just received this so have not used it a lot yet, but so far this appears to be a good buy. Easy to set up and use right out of the box and have gotten a clean cut on everything except heavier steel, which I'm sure is just operator error. Satisfied.

Product comes with all adaptive tools needed for power and air. Well made compact product does as advertised. You can cut up to a half inch of the metal it advertises you can cut stainless and aluminum. Practice makes perfect not much knowledge is needed to use and the directions walk you through everything. It���s a bit pricier than others but there���s a reason for that. Ease of use and product you get leaves you not running to the store for extra parts not sent with the unit

works well for small projects, no complaints

Been using this for about a month... Aluminum Dimond plate Galvanized and plate steel. From 1/16 up to 1/2 inch It has cut everything I've needed it to cut works perfect... Works so good that the owner of company I work for and one of the other mechanics that I work with have ordered one for there selves...