Seems promising - I hope it works. I won't know for a few days. Why - because I had to re-drill the hole for the bolt that runs through the main pole. Seems the Chinese didn't keep track of the ends. When the main pole is attached to the base plate, the angled supports that tie together on the pole miss the pole hole by an inch or so. If I turn the pole over the three pieces line up. However, the threads for attaching to the plate are now pointing up.This is steel so I have to re-paint to mitigate rusting where the new hole was made. Another gripe is that the manufacturer could not be bothered to provide more detail on how assembly should be done; e.g. which parts go where. Not difficult to figure out but... come on.