Customer Reviews for VEVOR 0.8L Professional Ultrasonic Cleaner 304 Stainless Steel Digital Lab Ultrasonic Cleaner with Timer for Jewelry Watch Glasses Circuit Board Dentures Small Parts Dental Instrument (0.8L)

After 10 to 15 uses, I can honestly say that it works exactly as it is intended. I have used cleaning solutions consisting of distilled water, distilled water and vinegar, and as you can see in the photograph posted, I have four linear bearings and one circular bearing in a WD-40 solution. I can confirm that you can use the heating function without using the ultrasonic cleaning. Please note however, once the actual temperature gets to the set temperature the heating function will turn off automatically. So if you decide to walk away from it the temperature will cool unless you once again turn on the heating function. I also observed the actual temperature display consistently reads several degrees below it's real temperature. With regard to the temperature, the bottom line is that it will ultimately get slightly above 80 degrees if that is what you want. At this price, and for cleaning bearings, or whatever else you may want to clean, that is inconsequential. I have found it easier to heat a cleaning solution a little before pouring it into the ultrasonic cleaner. It is not necessary but it will shorten the time that it takes for the unit to heat the solution to your desired temperature. If needed, I would purchase it again.

great ultrasonic cleaner for resin 3d prints. sturdy nice build and easy to use. not sure how the capacity is calculated, but doesnt feel like 2L.

Works perfectly and great value

This unit is well made and simple to use. The digital display is institutive and bright.I use this to clean my 3D resin prints prior to curing. Simple to use easy to clean.The perfect tool.

Did a really good job, temperature takes a little time to synchronize

Works great makes all my jewelery look brand new definitely buying another one

Works fine. Does the job for a decent price. Have used it for a couple hundred hours already with no issues. I am a hobbyist and not a professional in a shop and bought it for moderate use. So far, so good.

Bought it for cleaning small carburetors Works great

I bought this to clean my 3D printed resin prints and it works really well. No more sticky residue left on prints after cleaning! Simple, effective.

This is holding up well, I use it on a semi frequent basis and it works good, heater takes about 8-10 minutes to reach set temperature which is reasonable