Customer Reviews for VEVOR Label Rewinder, 120mm Width Label Rewinder Machine, Bi-Directional Rewinding Machine 220mm Max, Diameter Synchronize with Printers for Industries

Works as intended. We use with 1" cores which is the minimum and we have no problems. There is a small range of tension you can apply depending on the printer speed so that you do not have to pinpoint the exact setting each time.

Great price for it's purpose. There are many more expensive reminders that I almost purchased, took chance on this one based on reviews and price. Glad I did, feel like I saved a lot of money and time as this shaves about 45 to 60 minutes off our label printing process.

This is just a basic winder unit that works with our Zebra printer. It winds the labels back up as they are printed. It operates exactly as described, no issues or complaints.

Vevor is simply the best! I have referred them to friends in the industry And we are all amazed on pricing, quality and delivery time.

I've been using this product for a few years now, and it's still working as it should. It is a little noisy, and you do have to keep an eye on it while it's rolling up the labels to make sure it's not malfunctioning, but it's really good for the price point. Works as it should. Just look up the product youtube video before using.

Easy to setup and operate

works exactly as said. wish I had something to hold in place to unwind and rewind to.

Great product, works like a charm! It rolls well with our Zebra printer.Easy to assemble. Very happy with it!Roy

This rewinder does what it is supposed to do and is worth purchasing for the roughly quarter of the cost of other machines. It does have English comments over what I assume is Chinese instructions, so you can make out what the three buttons do. It rotates slower than the YouTube videos but does keep up once you pause the printer for the initial rewind start. It has a bar at the bottom that goes on top of what you rewind so it will throttle itself. Perfect fit for the Zebra 1" rolls we rewind (ZM400 printer.) We ended up using a little duct tape to hold the plastic spacer for the 1" rolls, but not a big thing. I would put loctite on the screws when you assemble it. The meta guide near the controls needs to be placed away from the yellow sensor about a quarter inch to allow it to spin freely. So far we have rewound about twenty rolls without issue (about six rolls a week.)Bottom line is it does the job, it is a decent product, and I'd buy it again. I would like to open up the product and add grease to the gears to quiet them down a bit. I would also like to know how to speed it up since it has the throttle bar at the bottom to handle the initial few revolutions.