Customer Reviews for VEVOR Rail Mill Guide System 9 FT Chainsaw Mill Rail Guide with 4 Wood Fixing Plate Rail Mill Guide Used in Combination with The Saw Mill

The item was state-of-the-art! Swift delivery. August packaging. Exalted seller.

I’ve milled about ten large trees with this so far. Works great once set up. I also have a Granberg and it works just as good.

Good product!

I purchased this guide to rip some logs into slabs so I could season and use the wood for future projects. The assembly was pretty simple. The plexiglass shield is virtually useless and I didn’t install it. I have a chainsaw with an 18” bar which ultimately ends up about 16” of useable length. This unit takes up about 4” of length so I could only cut a maximum of about 12” width material. It’s a little cumbersome to insert the chainsaw. Once inserted it’s not very user friendly to tighten the bolts down and you have to reach inside and around to get everything tightened. The steel pads that hold the chainsaw bar are almost as wide as the bar which leaves little room for clearance on either side so I ground them down a little to make more space. You also can’t overtighten the clamps on the bar or it will clamp the chain inside the bar and prevent from running through the guide. The end of the bar is where this becomes a bigger issue and I had to play with the bolt tightness to get it just tight enough so it wouldn’t slip but not so tight it restricts the chain. Depth adjustment is also a little cumbersome and you’ll need to keep a wrench for adjusting in the field. The measurement bar is quite accurate for the depth to within 1/16” which I found pleasantly surprising. Once depth is set and everything is ready it works well and will cut a nice line. If you’re considering buying a chainsaw to use with this guide get a powerful one! Mine takes about 3-4 tanks of fuel to get through an 8’ long x 12” wide oak log for one cut. It works but takes a solid 3-4 hours just to get through one log cutting 2” thick slabs. With a more powerful chainsaw I’m sure it would take maybe an hour which is a little frustrating. I’m using a Stihl MS-250 chainsaw. If I was doing a lot more of this I would get the most powerful chainsaw available to cut down on the time. Overall I’m happy with the product although it could use some advancements to make it more user friendly with faster setup a

This mill does what it is supposed to. It takes a while to assemble. I also found that the wrench included did not fit some of the bolts, which seems like a clear oversight. You still need a separate rail to make the first cut. Any straight object should work. I screwed down a 2x4 and it worked fine. Price is still pretty good IMO.

The product needed to be assembled with several smaller parts. All small parts were in plastic bags, however there were 2 small critical parts missing to hold other parts in place. Need contact info of the seller to obtain these parts or other options. Also contacted the manufacturer and awaiting reply.

Fácil y muy útil

Well worth the money. Gets the job done and seems to be quality materials

Making table tops it was what I hoping it was going to be .In more

Originally came with a poorly welded piece, contacted them and they replaced it free of charge. Very happy with their customer service. The mill works great now, it's a lot of fun and I highly recommend it.