Bought to change the bearings in my ford superduty rear end.I have not used yet but am keeping it around in case I do need it.Seams to be good quality.
I don't know why people have had problems with it being too small for any Dana axel. I've been using it on a Dana 80 and it works perfect for me. It is very well built. It is heavy but I assemble it on the axel which makes it no big deal to get it on the axel.
Does not fit under jeep. Buy shim drivers instead.
Too large toFit under jeep, even with 4” lift, would’ve needed to remove entire axleAssembly and use on the bench, I wish I would’ve purchased shim drivers instead.More or less serves the same purpose, and much less cumbersome, and you can useThose under any vehicle.
Im not sure what other people are talking about, but this definitely fit my later kingpin ford dana 60 (1990). Its a big hunk of metal, heavy, but works. Wish there was a way to measure the amout spread, instructions, or even to know the thread pitch (then u could cound flats to measure)
I finally bought this after doing many rears over the years and it made the job go so much easier. It is a quality product for the price and should last many years. Shipped really fast , I received the next day and immediately used it to re-gear two dana 44s.
Don Lewis 
