Customer Reviews for Dc Motor, 3/4hp, 56c, 90v, 1750rpm, Tefc, Base Grease, Permanent Magnet

Great value for money. Super quiet. Powerful. I was able to use it at 48V until I received my voltage booster. From 48V to 90V is a huge difference (ok maybe only twice as much). I also was able to run it on a Ryobi 40V battery by using one of the adapters that bring out the hot wires - one thing about this type of setup is that you could possibly ruin battery by completely draining it. Those types of batteries need some charge to recharge again. The motor fit right onto my speed reducer. I was worried about power, but it has plenty. I would definitely buy this again, and the larger 1 hp motor (could make a great go-kart - I think).

Great! Infinite speeds between zero and 1725 RPM. #1 DC motor running it on a drill press using a variac ( adjustable variable 20 ampere transformer) and bridge rectifier- it goes from zero to full 1725 RPM with the turn of a dial. #2 DC motor: On the 14 inch band saw, the second DC motor, is powered by a VFD with the three-phase output into a three phase bridge rectifier that feeds the DC motor. Finally fully adjustable speeds for when you need to cut metal to soft woods. Just Wonderful ! DC permanent magnet motors develop torque at extremely low RPM and worrying about fields and magnetic saturation of AC motors is not an issue with these motors. My Wish: I would like to see 90 VDC 1HP and 1.5 HP motors offered and be capable of being powered with simple Variacs or VFDs!!! Those 12 VDC motors require too much current to be useful.

I'm very happy with this motor. I have bought 6 already for my salt spreader and works very nice

Great value for the $$$ . Unfortunately it did not fit my project.

Great product arrived on time no problems

Awesome little moter...easily hooked to a pot

A wood turning lathe.

works great

Es buen motor no falla ya que tengo 4 trabajando y son buenos

The worst part about the motor is finding the right size brushes that the motor requires. Yes you get an extra set but after there gone good luck finding the right size brushes.