Customer Reviews for VEVOR 2KW Diesel Heater Muffler Diesel Fuel Heater 12V Diesel Air Heater Remote Control with LCD Switch for Car Trucks Motor-Home Boat Bus CAN

I have 4 I have one that if you up too high it says overheated and tuns off,a lower setting works good, my other ones work very well

There are several tricks to this heater. For one thing, the centrigrade won't go to Farenheit, so do not set it up to 35 degrees or it will overheat and stop.

This unit works well and can heat my 24’x30’x10’ finished and partially insulated garage to a workable temp. Raises temp from 45ish to a workable mid-upper 50s. I’ve used it about 20 hours and fuel usage has been about 2 gallons under moderate heat setting. I added a 10A 12VDC power supply, longer flex exhaust, and CO monitor for safe operation.

The heater itself works well like most of these... If you intend to use it in the enclosure as a portable unit, my fuel tank leaks so that would be a problem. If paying full price, some of the accessories are low quality (if it matters to you); but if you are getting it on sale for parts, it's excellent. Replace the marred up aluminum fuel barb in the tank or use something else as a fuel tank and it's good to go. The instructions don't mention anything about how to use the controller, but it's easy enough to figure out.

This heater is awesom. Super happy with the heater. I have went ahead and bought a second heater for the other building.

I'm heating my old 1988 30ft Rv with it. On the lowest setting i have 69 degrees. 2 days of heat , burns 1 gallon of fuel. I have a weak 12 volt battery that powers it. It powers it for about 12 hrs. Very impressive heater!!!! No fumes at all. So far it works flawless. Been running non stop for about a month. So far, an amazing heater!!

Very easy to install in my van

The heater came very quickly and had no damage. The controller is a bit confusing but if it is in manual mode it does fine it's a 1 - 10 setting. I ordered the non-blue tooth as no blue tooth version was in stock. If I can offer some advice make sure both the intake for the burner and the exhaust are not restricted in any way. As the heater performance and effectiveness can easily be diminished and take note the exhaust gets very hot. I routed my exhaust through an old 3 section cast iron radiator from an old house. It recovers a lot of the lost heat that goes up the stack and puts it in the room where you want it. It's enough so the exhaust tip is just warm to the touch as it exhausts outside. I also put a couple of 12 volt computer fans on the radiator to spread the heat around. Works great!

Works good to keep my tool trailer warm runs a little bit over 24 hours in a tanks of fuel keeps it at what ever temperature I have it set at so far the coldest weather we have had so far this year was 19f

This unit make great heat and is very warm. It's compact and you do have to do some cutting and splicing but it's not overly complicated. The cons are it doesn't shut off completely when a room temperature so you need a really good battery in your vehicle. The other is the instructions are written in very poor English and is difficult to understand and maneuvering the menu is a bit of a struggle. Overall the unit is a good bargain, you have to be patient with the instructions and using Celsius instead of Fahrenheit.