Customer Reviews for VEVOR Differential Housing Spreader for Dana Axles Fits for 30 44 60 70 80 Series

Awesome case spreader, it worked very well as intended!

Very well made and very heavy duty. I weighs 38 lbs. It's either powder coated or painted in a heavy enamel paint. I used on a Dana 60 rear end and it worked great. It doesn't need assembly instructions. It's very easy to figure it out. I agree with someones other comment that if you can't figure out how to assemble it. You should not be rebuilding the rear end.

Used on a Dana 60 to change ring and pinion , bearings and seals. Worked well. Must be assembled but is easy to assemble.

Worked great on my Dana 30 front differential. Heavy duty and heavy. Could not have gotten the carrier out without it. In my opinion worth every penny

Used for re-gearing my Jeep JK. As expected, it is big and heavy to accommodate all housings up to DANA 80. Anyone expecting it to be small and light needs to realize it is made to spread steel cast housings. I wouldn't take anything wimpier. Worked as it should with minimal effort. Steel is good and the welds are good. Not sure how it will work on anything bigger than DANA 44, but for what I used it, it was perfectly fine. It is a must, IMHO, if you are removing and installing a differential carrier PROPERLY.

Like; it did the trick. Dislike; WAY HEAVY.

Worked great on a dana 35.

Works like a champ! Must have for proper dana axle gear set up

I love it the only down side is its really heavy

Looks well built, would not fit Ford 8.8