Customer Reviews for VEVOR 1.5HP Electric Motor, 3450rpm Reversible Single Phase 56C Frame Air Compressor Motor 5/8" Shaft Diameter Electric Compressor Motor for Agricultural Machinery General Equipment, 115/230VAC

Fairly easy to install after adapting it to the task. Haven’t used it much yet but seams to work fine.

Besides a small mix up with wires not being marked, very happy with speed and operation.

It's a great fit for my older craftsman t hiable saw. It's like new again maybe better. The soft start is a real plus. It saves breakers. I have not tripped a breaker while using this motor. I use dato blades with no problem. I would buy it again.

It works great on our table saw. We like the duel voltage options and that it can be wired for clockwise and counterclockwise operation.

Allgood

it's a bit challenging to install because the MFG instructions are wrong; the wiring diagram on the actual motor is correct: for 115v: Black (power) goes to P1; T2, T4, T8 go to white (neutral); P2, T3 and T5 go together; Green grounds to body of motor. I purchased a switch POWERTEC 120V Magnetic Paddle Switch for it

Verify rotation before adjusting wiring. 110 wiring diagram is reversed I rewired and installed the motor only to find that it was correct to start with so I had to re-wire

My Craftsman table saw was built in1965. I went with this instead of a Craftsman motor from eBay. I use dado stacks and molding heads on my table saw, so the step up in power was very noticeable. This motor is enclosed. Hopefully that will protect it from sawdust.It’s was easy to install, no extra brackets or hardware. Re-wiring the motor to spin in the right direction was easy. No electrical knowledge required.Will update this post if something changes.

Motor arrived on time, well packaged and in tact. Directions were clearly available, changed rotation for application on table saw, and I look forward to using it. The 1/2” knockout had to be drilled out, but no problems.

Arrived on time, runs quiet and smooth like a charm. Really happy with this purchase. It is going to be retrofitted to fit my grandfathers original craftsman table saw. Glad I found a great motor that can be used to restore a piece of history from my family