Customer Reviews for VEVOR Ball Vise 5" Engraving Setting Tool 360°Rotation Engraving Block Vise 34 PCS Attachment Jewelry Engraving Block Tools Standard Block(5inch)

I haven't used it a ton yet, but it's a nice piece for start up.

The vice is well made. The attachments are the same as the GRC so if you wear them out you can upgrade the attachments by buying better-made ones.

Original GRS EQUIPMENT made in USA. BIG SURPRISE and fast delivery.

For the money this ball is a good value. Buyers will be much happier with the performance if they take it apart and give it a clean up. I did this by taking it apart removing all the oil, taking a file and removing all the sharp edged burs and bumps and putting small chamfer on all the sharp corners. I made a set of 220 and 320 grit sanding sheets for each half of the ball by cutting sheets in half and cutting a hole in the center for the center post to fit through. Put the ball back together ( with the bearing removed) with the sanding sheets in place and turn the halves against the sand paper for a while to smooth out these surfaces. I did this with the 220 and then 320 washed off both halves with solvent (WD40) and blew it all off with compressed air and wiped it down. Applied a thin film of teflon grease resembled the the ball, turned it a bunch to distribute the grease, then took it apart and wiped of all the excess. Reassembly with the bearing and the vise will spin 8 revolutions with one flick of the hand. When I got it it wouldn't make one full turn with the same effort. All in all I'm happy with this tool.