Customer Reviews for VEVOR Heavy Duty Leveling Casters, Leveling Casters Stem, Set of 4, 2.5", Retractable Leveling Casters for Workbench, 4400lbs Max Loading Capacity, 360-degree Swivel Casters for Industry Equipment

The casters are quality and strong. No specs were given on just how high you can go after lifting off the wheel so as to "level" the table. With my sloping garage floor I need quite a bit like 3/4" higher on one end than the other. These levelers go maybe 1/4" beyond (safely remaining screwed on to the shaft) but they retract about 3/8" so I can slide a shim board under it before cranking it up. That's pretty much the limit as levelers after you get roll it to where you want it unless of course your table is light enough to pick up and slide a shim under it. Mine is a heavy welding table to so the leveler needs to do the lifting.

They are perfect for our uneven concrete floor in our shop. We did end up having to uses wedges under a few casters after pulling wheel up but that was our floor not the wheel. would buy again

These worked great for the wood storage rack I built

well worth the money,they perform very well. Good value. Very happy with them.

Excellent caster. Put them on Stanley Vidmar cabinets full of hardware and they hold up and roll around just fine. Bolter two sets on qnd welded one set one without any issues. I plan to buy more for other heavy cabinets and tool chests.

Nice casters; well built; great price. Used one set on a 700# set up block on which I mounted a Delta Milwaukee shaper. Moves around the shop easily. Set the pads, (even just one), & it's solid as a rock without movement. Did crack one caster, (my fault entirely), when I set the block down too swiftly. The other three are fine. (Wish I could get just one to replace, but I just bought another set & now have 3 spares. Mounting was a breeze & very stable. Will be using a lot more of these around the shop on my welding table, welding rotator, surface plates, etc.

I had gotten casters like this previously and liked them but they were much more expensive. These casters are strong and roll easily even when changing directions unlike conventional wheeled casters. Highly recommended.

I put a 2000 pound milling machine on a set of these. They roll great considering the weight they are supporting. The machine can be turned, pushed and pulled anywhere on a relatively smooth concrete floor. The only issue I have with them is the thumb wheel will not turn under a heavy load. In my case it was easy enough to put a floor jack under the mill and lift it up until the thumb wheel turned easily. It took a few back and forth sessions from side to side to get everything level but now the weight is supported by the foot and not the roller. I am sure the roller would develop a flat spot if they were left supporting that much weight. This way they will be nice and round when I need to move the machine.

These are fantastic, we have an arcade machine that would be super heavy to move and try and use but these are super heavy duty and extremely useful. The wheels are well moving as well, so they will work in a variety of places.

I have purchased few sets of these for different machines that I have in the shop. love them