Customer Reviews for Magnetic Drill 1450W 12800N Portable Mag Drill Press 800RPM

I saw a utube video advocating for the cheapest mag drill on Amazon. The guy said it was pretty good, not perfect but more than adequate. Turns out it is and I'm one happy customer.

This drill is awesome. Stays perfectly in place while drilling.

This drill was purchased to drill 80 holes in 3/8" mid steel that are 1-1/8" in diameter. It worked just as well on the last hole than the first, flawlessly. When you get the drill, spend the time to adjust the 4 gib screws. It is time well spent to get the 'slop' out of the vertical travel on the ways. For the reviews that said the annular cuts only lasted 2-3 holes, I can almost guarantee you they didn't use cutting oil, or any oil for that matter, to keep the cutter lubricated and cool. They work great (I've used 5 different sizes and all have been of high quality). If you need a mag drill, or just think you might, definitely get this one and you will be very happy you did.

Own metal fab shop and use daily under heavy hard use conditions and it doesn't hesitate a bit worth every penny

I bought it do use with annular drills but the wobble was too great so I had to buy a chuck with an adapter and try to use regular drills to be able to use it. I had to make a run into town to buy hose So I could connect the lubricator to the chuck adapter

Used this machine for the first time last weekend. Arrived on time. Shipping box had a little damage to it, but didn't damage the machine. It is easy to set up and use. Magnet has plenty of pull. Didn't have any issues with my first use. It didn't come with a metal reservoir as shown in the picture, came with a cheap plastic reservoir. hope I don't have any issue with it tho.

Fantastic unit. Works amazing. Great product.

It's good , just fill the bottle with cutting sulution, set on your work do all your lining up then turn on magnetic switch , now with drill off move handle down check your specks , ready turn on dilution and then the drill juice on bit lite touch and easy set there and note it hole no hard pressure just easy and with the juice on the bore bit , this a must no juice no bore , and lite pressure , it's not a fast operation , it's not intended to be , but the results are the nicest , I've used $6000.00 drills and bore bits that the finish is no better than with this tool , note find you a plate bolt it to your work bench no clamps set your mag drill and u can drill plate to a degree on your work bench , good luck , and take ur time

It came with all the accessories shown. RPM was right, (300 rpm) for cuttingthicker steel.I am using it to drill 5/8", 3/4", bolt holes in I beams.In my opinion, this tool is of good quality for my requirements.

I bought this for my husband he is so happy with his new tool that is keeping him far away from hard job