If you want to plug and play and accuracy is not your goal, this little machine will render positive results. The lathe has the potential of being tuned to much higher tolerances, but it will require you to do some work. YouTube is full of great videos tuning your machine. In my case, I disassembled it, measured and corrected the hastily assembled product. The least you should do is to clean and deburr many parts. Grease is sloppily applied (if at all). There’s overspray on the ways. The carriage and tails stock don’t run smoothly on the ways. I lapped the carriage with 240 grit sandpaper strip glued to the ways. A lot of elbow grease, but it’ll make everything operate so much better. I’m planning on replacing the bearings with high quality angular contact bearings that can stand both radial and axial loads.I can go on for hours about all the improvements that can be made to this lathe. I knew all this when buying this machine, and it has not discouraged me from purchasing it. It’s still a great price, and you get a lot of bang for your bucks. Buy it.