Customer Reviews for Metal Manual Wire Stripping Machine Scrap Cable Stripper Copper Recycle Tool

I bought this to finally end my scrap wire pile. Finally an affordable device to do a very boring and tiring job. And this thing works. Just the way it is supposed to. Start a wire crank the handle and peel that casing off. Wow no more cut fingers or sore hand joints. I may even try driving it with my battery powered drill. The price was real reasonable, thsy ship super fast and it works.

The machine works great. A little tricky to line up small wire below 14 gauge to the cutting wheel, but it works. For us it paid for it self the first time we used it as it doubles the price of copper. Bare copper is $2.40 per pound verses insulated copper is $1.12 per. pound

this is by far the best wire stripper for the money, It 's easy to set up and use with the hand crank or set it up to use your cordless drill. I stripped out half a 55 gallon barrel of Romex in a very short time. This is a 5 star tool.

I have been using this wire stripper for over a month now. I think the most amazing thing is that I’m still amazed by the machines quality of build and ability to perform as stated or better. If one man was feeding a sec fast as he could two men could not keep up on the other side. One issue I had was the pull-up on the motor shaft came loose and would not retighten with the jetway provided. Turns out after some precise measurements the key way taper was reversed I simply drilled and tapped the pulley and installed with a set screw problem was fixed and we’ve been at it ever sunset. Now the only problem is finding enough wire to strip. I highly recommend this piece of equipment not for a homeowner version but for entry level industrial.

This unit works very nicely for the price range. easy to set up and so far has worked as advertised.

Blown away by the quality for the price. I would have expected this to cost twice as much. Works as described and looking forward to years of increased profits from processing scrap wire before recycling. Thanks Vevor!

Works awesome! Just make sure you get sharp kinks out of the wire first. Also, cut a few test strips when you are adjusting tension. Too tight will turn the wire into two inch long needles. Overall it’s a money maker!

So far I like how it operates, however; on larger stranded wire the outer insulation tends to jam up and you practically have to take it apart to un jam it! It could also have a diverter of some sort to pull the discarded insulation away from the wire as it’s being stripped!

as all tools it has its flaws but from a stripping wire stand point it is way faster than doing it by hand highly recommend

I was able to strip 112 lbs of welding cable in three hours, right out of the box.