Customer Reviews for VEVOR X-Axis Power Feed for Milling Machine, 150 in-lb Torque, 0-200RPM Adjustable Rotate Speed 120V Power Table Feed Mill Feeder, for Bridgeport Some Knee Type Mills with a 5/8" End Shaft Diameter

As most have said, some fitting is required. For me, the key way for the lead screw woodruff key was too narrow and too short. I used a hand file to open it up. Did a little bit at a time. Everything else fit the way it should have. I have a Bridgeport J-head. It works well though. The instructions are terrible. That’s what had me drop it to 4 instead of 5 stars.

The unit fit everywhere except the adapter plate. They sent an adapter that fits the X axis which is much smaller. After several days of emails back and forth they decided to send a small refund to make me happy. I made the correct adapter and the unit works OK. The extension shaft is not made true-so when in operation the unit wobbles around. For the price paid I guess it is ok. If anybody needs a drawing of the correct adapter , I have the one I made in solidworks

Muy buen producto

I think it is going to work fine. I had to do a few mods to get it to work on my Rockwell 21-120. Added some 9/16 to 5/8 bushings on the Rockwell feed shaft and made a custom inner race for the Vevor feed. Shortened the Vevor ring gear and ground a new key-way. Made a new mount using 1/2 inch aluminum. I have used the mill several times with the new setup and it's worked fine. I would give it 5 stars if they made a kit that fit a Rockwell!

This unit is a welcome upgrade to my Bridgeport style knee mill. Only one issue is the keyway for this unit doesn't match the keyway for my Bridgeport style unit. This was easily remedied by narrowing the key where it sticks out, until it slid into this units keyway.

We’ll build

really great value. works good and fit my enco mill except key slot is smaller had to machine key to fit. would be great if it came with a stepped key then would work on almost any thing

Amazing product works very well

Other than the plastic drive gear, these units perform as well as the high dollar SERVO brand units. The plastic drive gears are the same as the other brands, so we stock them as a routine maintenance item.

I have a Taiwan Bridgeport clone from the mid 1980's that was missing the X-axis powerfeed. The VEVOR AI-310S powerfeed is a really nice upgrade from the manual turning and provides a much better finish to my parts.