Customer Reviews for Power Feed Y-axis 135lbs 200rpm Torque For Bridgeport Type Milling Machine 110v

I think it is going to work fine. I had to do a few mods to get it to work on my Rockwell 21-120. Added some 9/16 to 5/8 bushings on the Rockwell feed shaft and made a custom inner race for the Vevor feed. Shortened the Vevor ring gear and ground a new key-way. Made a new mount using 1/2 inch aluminum. I have used the mill several times with the new setup and it's worked fine. I would give it 5 stars if they made a kit that fit a Rockwell!

This unit is a welcome upgrade to my Bridgeport style knee mill. Only one issue is the keyway for this unit doesn't match the keyway for my Bridgeport style unit. This was easily remedied by narrowing the key where it sticks out, until it slid into this units keyway.

We’ll build

really great value. works good and fit my enco mill except key slot is smaller had to machine key to fit. would be great if it came with a stepped key then would work on almost any thing

Amazing product works very well

Other than the plastic drive gear, these units perform as well as the high dollar SERVO brand units. The plastic drive gears are the same as the other brands, so we stock them as a routine maintenance item.

I have a Taiwan Bridgeport clone from the mid 1980's that was missing the X-axis powerfeed. The VEVOR AI-310S powerfeed is a really nice upgrade from the manual turning and provides a much better finish to my parts.

I figured I'd need to make some changes during install and was not disappointed. Had to make a stepped key to drive the bronze gear and a short 4mm key for the handle . Unit works pretty well but does not stop on the limit switches like a Servo feed does

Works great.

This power feed was used on a grizzly 10x50 mill that is no longer made and it worked fine. It was easy to adapt.