Customer Reviews for VEVOR Rear Axle Bearing Puller Tool 09521-25011 for Toyota Trucks(2 Pack)

thanks for your tools, im been over 20 years costumer! thanks again thanks for your tools, im been over 20 years costumer! thanks again thanks for your tools, im been over 20 years costumer! thanks again thanks for your tools, im been over 20 years costumer! thanks again thanks for your tools, im been over 20 years costumer! thanks again

I'm very happy i found this puller on your website. great price and fast shipping. This tool made my job a lot easier Thank You

Great product and made with quality!

Works perfectly well..

This tool worked to press out rear axle bearings from my 2007 4Runner. As others have commented, I couldn't use a HF 20T press as delivered. The two channel irons for pressing against are welded together and the axle tool won't fit between. I got two 27 inch lengths of 5X9 channel from a steel supplier to replace the HF part. This allowed the axle and tool to be installed in the press. The difficulty came because the 5" height of the channel iron was about 1/8" more than the inner distance between two flanges on the press tool. So, the channel iron couldn't close up against the press. I ground the flat surface of the lower flange on two sides until the channel iron cleared. That took longer than pressing the bearings off. Maybe smaller channel iron would work too. The 5X9 are pretty heavy and didn't even notice the pressing.

heavy duty, nice welds

This puller unit works fine

This product was completely as expected. This is another tool added to out tool box in order to serve our customers better. This tool is built very well constructed and should last a very long time.

WELL MADE TOOL, THIS WILL HELP SAVE TIME AND MONEY, BY NOT HAVING TO CUT OFF BEARING RETAINER.

Worked great on 2012 Tundra! Had to modify the end with the smaller flange as it would not fit in my 20 ton Harbor Freight press. I modified this tool by cutting 2 sides of the flange. You will not be able to use a 12 ton press as it does not have enough pressure to break bearing from drive shaft.