Customer Reviews for VEVOR Rear Axle Shaft Bearing Puller for Toyota Trucks (1984/2018) 09521-25011-0(1 Pack)

I've used the Toyota tool at the dealership and this one works just as well !

fast shipping, grear price

Nice tool for the job. Very well built. The only issue I had was that neither flanged end would fit in my Harbor Freight 20-ton press. I had to cut one end off to be able to finish my job. No one claimed that it would fit in the 20-t press, so that's on me. Other than that, it worked fine and I can weld a piece of tubing to the flange I cut off if it's needed for a different vehicle.

Fits perfectly an heavy duty

Worked just like advertised. Very happy the my purchase

Built well. Very Stout and versatile.

This tool worked perfectly on my 2008 Tundra to replace the rear wheel bearings.To get it to work on the Harbor Freight 20 ton press, I bought two 27" pieces of steel channel, four pieces of steel tube as spacers, four bolts, eight washers, and four nuts to make a new work surface for the press that could be unbolted to allow this tool to fit inside. I also had to cut the lower support on the press for clearance, then anchored the press to a pair of 2x6s to keep it stable.

Fits multiple vehicles.

It worked well on my 2010 Tundra but the flange is 5in wide at the smallest point making it incompatible with most presses. Had to modify my press to make it work. Otherwise it is very heavy duty and we'll built.