Customer Reviews for VEVOR Professional Ultrasonic Cleaner, 10L Ultrasonic Jewelry Cleaner with Digital Timer & Heater, Stainless Steel Industrial Sonic Cleaner 40kHz for Glasses, Watches, Rings, Small Parts

Sophisticated unit for the funny price.

Very beautiful basket, it feels very textured, and has a clear temperature display, very good product

May 15, 2019 Cleans excellent.This is the 2L model digital JPS-10A. It is actually a 1.4 L (48 Oz.) I use it to clean my 420 pipes. When the heat reaches temperature the on/off light goes off however the current temperature flashes, usually within 2 degrees. Ultrasonic itself creates heat and the heating element also creates heat. I used nail polish remover heated which worked wonders and cleaned perfectly. I had monkey pipes glass, metal, and wood, all at once. Used 16oz fl. I did not use the basket. About 20 minutes two times. It works fine. I know I wanted size, heat, depth, digital, and Ultrasonic. Ultimately, I used a small glass with about 4 Oz. isopropyl alcohol in a water bath. About 2-3 20 minute cycles refilling the alcohol with new clean alcohol after each cycle worked perfectly.

Bought this to clean uncured resin from 3d prints, and it works amazingly for it. The size is perfect for prints from the anycubic photon.

Saw a similar product specialised for cleaning glass marketed for a much higher price. Does everything I need it to can’t beat it.

Bought it for cleaning small carburetors Works great

Great. Cleaned my motorcycle carburetors perfectly. Will see how it holds up with repeated use.

Works fine. Does the job for a decent price. Have used it for a couple hundred hours already with no issues. I am a hobbyist and not a professional in a shop and bought it for moderate use. So far, so good.

I use it for album cleaning works awsome for my needs

After 10 to 15 uses, I can honestly say that it works exactly as it is intended. I have used cleaning solutions consisting of distilled water, distilled water and vinegar, and as you can see in the photograph posted, I have four linear bearings and one circular bearing in a WD-40 solution. I can confirm that you can use the heating function without using the ultrasonic cleaning. Please note however, once the actual temperature gets to the set temperature the heating function will turn off automatically. So if you decide to walk away from it the temperature will cool unless you once again turn on the heating function. I also observed the actual temperature display consistently reads several degrees below it's real temperature. With regard to the temperature, the bottom line is that it will ultimately get slightly above 80 degrees if that is what you want. At this price, and for cleaning bearings, or whatever else you may want to clean, that is inconsequential. I have found it easier to heat a cleaning solution a little before pouring it into the ultrasonic cleaner. It is not necessary but it will shorten the time that it takes for the unit to heat the solution to your desired temperature. If needed, I would purchase it again.