Customer Reviews for VEVOR Motorcycle Shelter Storage Waterproof Motorbike Storage Tent Oxford 600D Silver Color 106.3"x41.3"x61" Motorcycle Shelter Shed with Carry Bag Small

I bought this for my 2012 HD Dyna Wide Glide and it fits perfect. I mounted some 4x4's along 3 sides of a piece of 3/4" treated plywood and attached the cover frame to the 4x4's after reading another review that did that, as I did not want to anchor it to the ground. It worked beautifully and I'm very happy with it. So far, It has held up to snow, rain and wind. I highly recommend this cover.

Very strong lasted for (3) until it rusted out on front frame, But water stays on top

Should be alittle larger for Harley Davidson

These are perfect for storing our dirt bikes and protecting them from the elements. We bought two and were able to store one dirt bike and one bicycle inside each of them.

Only thing is the bars could be a little taller they seem to slightly catch mirrors even when folded in but otherwise awesome

Easy to put together fits my 2022 indian scout icon 1200cc fine lots of room you do have to stand it straight when closing or opening or it will catch on the mirror but besides that I love it nice being able to just pull in and close it up

This is much better than a simple motorcycle cover. It's kinda thin but it keeps my motorcycle clean for the most part. What's really nice is that it just pops right over your bike in a second, no need to wait for the engine to cool down.You are supposed to anchor it, but it won't fit over the motorcycle with out a bit of a lift over the handle bars. So I can't see how it could be anchored. At least for me. I think it's cheaply made, but probably a good value if it lasts for a few years. Time will tell. It's March 2023 now.

Tough maternal

Where to start..4 of the poles had flaking paint already and rust beginning. Quick rattle can paint touch up but a bad start. The instructions are worthless but not too hard to assemble. Which way the fabric cover installed was trial and error especially as the cut outs on the bottom are in the wrong place. FYI, the reflective stripes are at the entrance.I chose to add stainless washers and nylon washers at the hinges for wear, the bolts are long enough. However caused myself work as the pole lengths are different and the pin has to face in.. this sucked up some time as I did it wrong a few times but this is my fault. Although a $2 addition at the factory would fix this. Finally pay attention to the height. I ordered one that had the correct total height BUT after all this I can't get the bike in because when the front is folded up the first bar is 5" lower that the highest bar...10/29. Adding that the customer service, while slow through email was consistent and we worked to a suitable resolution so you can at least be confident if you have an issue it will be resolved.

Does the job very convenient option for covering 50cc scooter