Customer Reviews for Ultrasonic Cleaner Ultrasonic Jewelry Cleaner 77L Heater Timer Sonic Cleaner

I use it for album cleaning works awsome for my needs

After 10 to 15 uses, I can honestly say that it works exactly as it is intended. I have used cleaning solutions consisting of distilled water, distilled water and vinegar, and as you can see in the photograph posted, I have four linear bearings and one circular bearing in a WD-40 solution. I can confirm that you can use the heating function without using the ultrasonic cleaning. Please note however, once the actual temperature gets to the set temperature the heating function will turn off automatically. So if you decide to walk away from it the temperature will cool unless you once again turn on the heating function. I also observed the actual temperature display consistently reads several degrees below it's real temperature. With regard to the temperature, the bottom line is that it will ultimately get slightly above 80 degrees if that is what you want. At this price, and for cleaning bearings, or whatever else you may want to clean, that is inconsequential. I have found it easier to heat a cleaning solution a little before pouring it into the ultrasonic cleaner. It is not necessary but it will shorten the time that it takes for the unit to heat the solution to your desired temperature. If needed, I would purchase it again.

I use this in my shop for Carburetors and Distributors . Works awesome and have no complaints about it at all. Love the heater and getting things clean. Being able to submerge the parts fully and having the room to put in other parts in at the same time. It’s about the perfect size!

Gets all kinds of junk you can’t see out of carburetors, perfect for a small engine shop possibly a little small for a full blown bussiness but for a start up small engine bussiness or a person just cleaning some carberators it’s a great little tool

I bought this to clean engine parts from several projects I’m working on and couldn’t be happier with it. It does take a while to heat up but I found if I use warm tap water to start with it heats faster. A couple suggestions from YouTube helped a lot. Use simple green and Dawn dish soap to clean greasy parts. Smaller parts can be put in a glass jar to save on solution. Put solution in the jar and water in the tank. As I keep the machine on a table I added a thin hose to the outlet valve to empty the tank into a bucket. Last thing, put a foam weather strip on the lid to reduce the vibration noise.

it is good product but if you are expecting to use big piece it is not big as much as you think

This cleaner works absolutely great on brass casings and I imagine on anything else. I am very satisfied. Just finished first batch of cases. Put on 8 minutes. Cleans pockets very good

Smaller than expected. Go larger for a single Motorcycle Carburetor. Will only submerge apx. 80% of typical motorcycle carb. Works Okay...no miracle cleaner.

I can not believe after all these years, I finally bought this. I cleaned a carburetor, and you would not believe how much dirt and grime I got out. I can put gears, gun parts, trigger assemblies, wheel cylinders. Every garage should have one.

I am using the unit to clean my bicycle chain. I purchased separately a detergent to use. Unit and cleaner does a very good job of removing accumulated 'gunk' from the chain. Have not yet removed the cassette for cleaning, but expect similar results. Am going to experiment with other cleaners, as this is water based. Only issue is with the heater. Takes a great deal of time to raise the cleaner's temperature. More heat, less time using the ultrasound. Overall well pleased. Expect chain life to be extended thus the unit will pay for itself in time.