Customer Reviews for VEVOR 1/2HP Furnace Blower Motor, 208/230V 2.7Amps, 1075RPM 5 Speeds, CW/CCW Rotation, 48 Frame 3.4" Shaft Length, 7.5μF/450V Capacitor + 11" Hold Hoop

I'm replacing the motor on my evaporative cooler, which is a 2-speed motor. This one from Vevor is a 4-speed, so it has additional wires. On my cooler there are 3 wires - black, white, and red. The red wire is supposed to put the motor into low speed. I've connected the black wires together and the white wires together. That leaves the blue, red, and gray wires coming from the new motor. I've tried connecting the red wire from the cooler to each of the blue, red, and gray wires on the new motor, but it will only run at high speed. I'd like to be able to run the cooler at low speed sometimes. Any ideas? Thanks.

Motor was easy to install. Brackets that came with it didn't work out, so we used our old ones. Motor is a multi speed for different applications. Got it installed and running and it is super quiet. Fit and finish was really good. Motor did come with its own running capacitor, a 7 micro farad size.

Replacement for a old ac unit. I had to change rotation just switching the orange and yellow plug around simple enough it replaced a 3 wire setup I used both brown wires and black for high speed. Be smart and careful with electricity an good luck. If it quits or has problems I'll change my review

Retro fitted into my Trane system actually blows well easy to install pretty straight forward and for the money great buy.

Used this to replace a useless, problematic X13 motor that would just sit there and rock sometimes until it finally bit the dust after only a few years. This one starts instantly and has performed great. All I had to do was add a relay and I used the same start/stop circuit board that came with the AC unit.

Great motor put many of these in Mobile home units with no problems. Bought some extras to keep on hand. The Price of these motors is awesome.

This motor works well, and can save a lot of money especially compared to a technician recommending a new furnace for $5000 or more. My original blower motor was installed incorrectly at the factory. Apparently, the mounting holes were not placed correctly so the factory installer removed a sleeve from one of the three isolation mounts to thread the screw into a misaligned hole. Also, the holes were not parallel to each other, making the new mounting brackets not fit. I bent the new mounting brackets and used two of them and one old one. The impeller is not centered in the housing, but rotates smoothly. There is no rumbling with operation, and the fan and motor are at least as quiet as the old one, but probably less noisy. The capacitor is round and would not fit where the old one was, so I mounted it on the sheet metal of the furnace instead of on the fan housing. Also, I had to use heat-shrink style crimped connectors for the wiring. The product is great, and I am pleased Amazon carries it. But if you expect a 30 minute installation, your experience may not match your expectations. The directions are poorly written English, probably simply machine translated from Chinese, and I think the coil resistance values are nonsense. I studied wiring diagrams before I started, twisted an allen wrench getting my old set screw loose, used a hammer and punch to remove the old motor shaft from the impeller, and drilled holes in my cabinet to mount the capacitor. The reward was perfect operation when I applied power to the furnace at job completion.

Unbelievable price and shipping was fast. Motor worked like a charm. I will be ordering more today and I will save this part number for future purchases.

This saved us from having to get a $550 motor. It runs amazing and it’s not much louder than the original

Works perfectly!! Saved me thousands on replacing the entire heater!!