Customer Reviews for VEVOR Hydraulic Exhaust Pipe Expander, 1-5/8" to 4-1/4" size, 10 T Manual Hydraulic Pipe Stretcher w/4 Dies and 2 Storing Case for Copper, Aluminum Tubes in Car Repairing

Great product with a great price. I wish I would have bought one a long time ago.

I hesitated on purchasing this in this time of cheap knockoffs that can’t compete with the real thing. But, this is the real deal. I have worked both 3/16” and1/4” brake lines with the required double bubble flare, both on and off the vehicles. Couldn’t be happier. They are precise, and don’t leak when assembled. Time will tell about how long it performs, but it comes with extra seal kit if required. Don’t screw around with brake lines, this will keep you safe.

It's a great setup it works flawlessly had nothing but good things to say about it done a few brake lines done a few transmission lines already with it and I cannot say how great this thing works it's just works flawlessly

Purchased this set for miscellaneous projects around the house. I’ve had this for a couple month and I really like the quality of this set. Highly recommended

Great tool for the price. My only complaint is the bulkiness of this compared to other hydraulic kits. The inserts are quite large, but it still works good.

This is really good for copper but when using stainless steel it doesn't seem to work really good try to use it on stainless steel and it didn't work too good

Makes brake line ends fast. I saved a lot of time using this tool. Just be sure to prep the lines properly.

Awesome to use perfect flair every time highly recommend would buy again for the price you can't beat this

I'm glad to have purchased this item. It works well and makes an exhaust installation much easier.

I bought this primarily for the double flare feature, specifically the 3/8'' tube size and wanted to use it on stainless steel tube. That said, the first time I used it the 3/8'' tube just pushed right out of the holding die and didn't produce a double flare at all, just a single flare with a small double edge. Frustrated, I tried it again with the tube protruding further from the die, thinking I just hadn't had it tight enough or the tube wasn't far enough forward. Same result, and this time I'd marked the tube and could see how much it had pushed back out of the die. To make a long story shorter, I put the two die halves into my mill and removed .008'' from each mating face and now it works correctly. I didn't think that should have been needed, but it was, at least for the 3/8'' die set. I haven't used any of the other die sets yet so don't know if this is going to be needed on those as well, we'll see. Anyway, all the dies and the corresponding flare mating tools are in the kit, maybe it needs to be fine tuned a bit, but the price is right, the hydraulic part works really easily and I'm happy, lots of stuff you buy nowadays doesn't even work; all the parts are here, it just needs a little finessing.