Customer Reviews for VEVOR Annular Cutter Set, 6 pcs Weldon Shank Mag Drill Bits, 1/2" to 1-1/16" Cutting Diameter, 1" Cutting Depth, M2AL High-Speed Steel, with Pilot Pin and Portable Case, for Using with Magnetic Drills

I purchased this annular cutter set along with a vevor mag drill, I have used them on many different projects, and they cut very well, I always use them the way they are intended and with plenty of cutting oil, and so far ,they are holding up very well

These annular cutters are so so. The mag drill is terrific! I recommend Cleveland Steel Tool Company for annular cutters. Their cutters are much more durable and very reasonably priced! I used the 5/8” cutter to drill almost 375 holes in my 1/2” thick fab table. I think the cutter cuts as well now as it did the first cut. Highly recommend!

Badass product for the price! Used and abused still holding up GREAT. If you’re looking for an affordable cutter look no further and get these. I promise you will not be disappointed! VEBOR MAKES EXTREMELY BADASS PRODUCTS AT A GREAT PRICE!

These bits are very sharp. They cut a perfect no burr hole with little effort. We use them to drill 5/16” angle iron with no trouble.

I bought this set for my vertical mill. Also bought the Accusize R8 to 3/4\" Weldon arbor to hold the cutters. Unfortunately the arbor had big bore runout and had to be returned. Most likely will make my own arbor out of a 3/4\" end mill holder. The cutters come in a nice plastic box. Each cutter is secured in a rubber insert plus the cover has a foam cushion. All cutters are nicely ground and sharpened. The cutter ID is 1.25\" deep, so it will allow a little more than 1\" drilling depth. Both OD and ID are tapered to reduce friction and provide for a free cutting action. The shank diameters are very uniform and are about .0005\" below 3/4\" nominal size. The tool set includes a decent 8 page printed manual. It is written in Chinglish of course, but it is a nice touch. I did not use the cutters yet, but this looks like a very nice tool set. I could not check the heat treatment and I have seen a few reviews with broken cutters. The time will tell a full story. Wait for the update.

They are pretty good for a cheap set. I have only use them a few times and they worked. I do not expect them to last a long time.

Good quality bits, I just wish you could buy a set of all the same size that gets used most. Drilled 60 holes with one bit and still working like new.

Great cutters for the money. Will hold up to a lot if used correctly.

Very disappointed with the VEROR company. THEY SOLD ME THIS ANGULAR CUTTER SET ALONG WITH A MAG DRILL. THIS CUTTER DOES NOT FIT THE DRILL THEY SENT ME. THEY HAVE THE WORST SERVICE DEPARTMENT EVER NO SERVICE PHONE NUMBER TO CALL. I’VE ASKED HIM A HALF DOZEN TIMES TO LET ME KNOW WHAT BITS WILL ACTUALLY FIT THIS DRILL. I STILL HAVE NOT RECEIVED ANY INFORMATION BACK YET. I WANTED TO SEND THESE BACK AND GET A REFUND. WHICH THEY WILL NOT DO. SO ANYTHING YOU BUY, THEY WILL NOT TAKE BACK! VERY DISAPPOINTING COMPANY!

Great cutters great price nice carry case to we will see if they last a long time my bet is they will