Customer Reviews for VEVOR Bucket Tooth Bar, 66'', Heavy Duty Tractor Bucket 8 Teeth Bar for Loader Tractor Skidsteer, 4560 lbs Load-Bearing Capacity Bolt On Design, for Efficient Soil Excavation and Bucket Protection

You sent me 2 of these and charged me . I returned one to sender and have not received credit on the one that was returned please do this asap . Thank you

I decided to weld it to the bucket and this monster really performs. It is well built and in doings so was able to take a big load off of the tractor by simply plucking trees and brush out of our grove. reduced time by 60 70 percent vs.. a smooth blade,

Arrived 3 days earlier than predicted and seems to be a nice heavy good quality bar. The large 15/16\" bolts and nuts are not needed unless you wanna drill holes in your bucket for a more permanent mount. I just used the 5/16\" allen wrench set screws at the top of each tooth and its on there plenty secure for me digging in shale and clay. Only suggestion is turn all the allen head set screws out some before trying to slide it on and use a hammer or wood block to tap it back tight on the bucket. Its mounted on a 2024 massey ferguson gc1723e tractor.

I was very impressed with quality and ease of use. I have a JD 1025r and the bar fit perfectly. The teeth are the rock teeth style and seem to be tough enough, not sure where to buy replacements. The bar comes with bolts if you want to bolt it on but I preferred using the allen screws that are in each tooth shank for easy on and off.

Great product and affordable. I have a mid-sized tractor and trying to dig and level parts of my yard was nearly impossible due to how hard the ground is. Added these teeth has made the difference!

Nice piece of hardware for my tractor. Nice piece of hardware for my tractor. Nice piece of hardware for my tractor.

heavy duty bucket attachment, Fit perfectly on my JD 1023e. Bucket will now remove turf and light brush. First job it tackled was pulling poison Ivy roots, worked great. Attached easily with an allen wrench.

Fits over cutting edge good and set screws draw it tight but bolt holes don't align with holes in bucket. I only had one align up and had to drill out two others that parcely aligned up.

I actually bought a bigger one and cut down to fit my bucket. Does what it is supposed to do. I would say go for it if you're on the edge.

Installed this bar on my Bobcat CT1025 and it is a nice upgrade. It is tough, digs great and tears out heavy brush with ease. Installed easily. I did have to cut a 1/2 inch off the sides to make it fit on my bucket. I do like the rivet fastening system.