Customer Reviews for VEVOR Chain Grinder, 110V 85W Chainsaw Grinder, Multi-Angle Adjustable Chainsaw Grinder Sharpener 5000 RPM, Bench/Wall Mounted Automatic Chain Sharpener with Grinding Wheels 1/8-Inch-by-3/16-Inch

Got two stones, but easier to use if make base at you can clamp down to the work tablets

Unit arrived well packaged; assembly was fairly easy except for mounting the grinding wheel. The directions shows that you have to insert a key into a hole in the arbor via a hole in the wheel guard. The problem is that the hole in the wheel guard does not line up with the hole in the arbor. Had to insert the key at an awkward angle. This made getting the wheel on and tight difficult. The chain clamp does not clamp the chain when it is in the groove. The clamp will work without a chain in it. Need to try and adjust it so I can get a chain to clamp before I can actually use it. Had to go back to filing my chain until I can get time to see if I can get the clamp to work. May not need the clamp as the stop may be able to hold the chain in place while grinding. But with wood to cut I have not had much time to play with it.

Great little machine. Chain vise could be stronger

Made well... A little bit of patience is needed putting together. Not the easiest to install the grinding disk. There is a hole at the bottom between the disk and motor to keep the shaft from moving when installing the disk. Slide a small screwdriver in the hole to hold the shaft. Practice is a must so use a crappy chain until you get the hang of it. Grinding disk is fragile so get a better one from the start.I'd buy again for sure. Just replace the disk from the start.

This a very good quality for being half the price of an Oregon. I have used an Oregon and I can't see or tell the difference.

Great Machine good quality

This was a gift for my husband. He really liked it.

Very easy to use… product works great

This here thing is a little tricky to get set just right on the saw but once you do ain’t nothin to it ya work right on around the blade a twist of the grinding wheel and hit the other side of the chain and done ten minutes took me a little longer the first time as I didn’t mark the link I started on and went around a time and a half

runs great, looks great, set up was good, after putting the 2 ball bearings back in vices part. had come out in shipping. only 2 of them was in box so i guess that is all of them. plug in started up when turned on. shipped on time. good to deal with. hope in time will deal with a gain. don't like to give bad revues for anything if can help it. so do not have any for this. so do not have a wary for this. it is great.