Customer Reviews for VEVOR Core Drill Bit, 1" Wet Diamond Core Drill Bits, 14" Drilling Depth Concrete Core Drill Bit, 5/8"-11 Inner Thread, Laser Welding, Diamond Wet Coring Bit for Concrete Brick and Block

GREAT BANG FOR THE PRICE. GREAT QUALITY. EASY TO HOOK UP. EASY TO USE. I INSTALL EXTERIOR METAL RAILINGS. INSTALL 2" PIPE TO CONCRETE. CORE HOLE FOR INSTALLATION OF PIPE.

Performed well through 8" of solid concrete. Tracked solid, even with a hand drill. Would buy again and the price was great which also included the bit and cutting wheel.

The product worked great other than the Allen screw that holds in the drill bit. It doesn't hold it in tight and if you try to tighten it, it will break.

I'm giving it 5 stars because it did exactly what I bought it for. The price was great! The pilot bit was the weak point as it didn't really keep the core drill centered to start the hole. It wobbled all over due to its length. I was able to chisel a starting ring and from there the core drill did its job. It even cut through the rebar that I unluckily encountered. You have to be patient and take frequent breaks to allow the core drill bit to cool. This is required with all dry core drilling.

This is an awsome core drill, i was skeptical at first, because of some bad reviews i saw. But this thing went thru a foot of rock wall with no issues. Bit is still intact,all teeth are good. Would definitely recommend it.

I bought this bit to bore a 4 -1/2" hole in my 5in thick, steel reinforced concrete in my upper patio to drain the Dry Below system. I used a 12 A hammer drill in drill mode. I used a little water and the bit walked through the concrete and steel in about 10min using no pressure just the drill motors weight. This bit performed perfectly. Thanks for asking.

I am very pleased with this purchase and it does a wonderful job, great value and paid for itself in less than an hour!!!

Perfect for what I have to on my projectI love it, It really with it for the money I paid for it lo

Now, this is a Diamond head drill! Awesome!!

This bit worked really well once it gets started correctly and is kept wet with a constant stream of water, but that’s a given when drilling stone, block, brick, or other forms of masonry. I drilled though red brick and the concrete block just behind it in about 10 minutes. But the pilot bit is terrible. The way that the arbor at the top of the drill tube is machined causes the pilot bit to be very lopsided. I fixed this by two different methods. The first, I put some tough wire around the pilot bit at the edge of the tube (see the picture) and I centered the pilot bit by using three pieces of wire one attached to every other tooth on the tube, I tightened the wire with lineman pliers. That worked ok as the wire would break away once the drill tube started into the block but before the pilot bit would go off to one side. But then for another job I improved on my design and drilled a three inch hole with wood hole drill into a piece of one inch wood. I sanded down the edges a bit so it would fit the tube loosely. I then placed this cutout, with a little black tape wrapped around it to make it snug, into the very front of the tube (see the other picture). This worked extremely well, as the drill tube went into the block, the wood cutout traveled up the drill tube. But once I got about three quarters or an inch into the tube I removed the wood cutout and the pilot bit since neither were necessary any longer. The bit sailed through the brick and concrete block. Perhaps the manufacturer could make a design change and have an insert that would keep the pilot bit centered but also ride up the tube as you bore the hole. All in all, this a good product for the money. Just remember to have someone help you and keep spraying water right onto the front of the bit and into the hole you are drilling. No matter what, never drill masonry dry, your bits will last much longer if you keep them cool and wet.