Customer Reviews for VEVOR Heated Towel Rack, 8 Bars Design, Polishing Brushed Stainless Steel Electric Towel Warmer with Built-in Timer, Wall-Mounted for Bathroom, Plug-in/Hardwired Tested to UL Standards

Heats well and looks good. The on/off decal was blemished, but we needed to proceed with the hardwired install. Install was not too difficult, but not as easy as it could have been. The leg where the wire passes is not able to be secured well unless you have access inside the drywall, which you need anyway if you are to make the connections in an actual electrical box.

Received it fast. Box had some damage but not the towel warmer itself. I hard wired the installation. Instructions are minimal but can be figured out. Got the wired finish and matches OK with other brushed fixtures in the area.Functionally it warms up fairly fast. I usually set off the time about five before I shower and the towel is warm. We use It to hold two full size towels folded into thirds lengthwise. It would be nice if timer had more options than just 2 and 4 hours but having a timer at this price point is hard to find if at all. FIt of a cople mounting set screws could have been more precise but overall acceptable for the money. Had it for two weeks now and no problems so far. Can't say about the future

Another perfect product!!!

Perfect product!!!

Looks great, works great, and easy to install, too. The only caveat was that when I read it included a timer, I expected that when I'd like to take a shower at 7am the next morning, I can set a start time at 6 so my towels will be all warmed up when I need them .Well, that's not what it does.It's more like if you are planning to take a shower in an hour, and then forget to do so, the timer will make sure the towel warmer is switched back off. With other words: mostly useless.

Works great, love the timer shut off feature.

Really good for drying unmentionables

My bathroom is small and this item fits perfectly. As mentioned in other reviews, the installation instructions are lacking a lot! But sitting down with the booklet and the actual hardware I was able to figure things out. The hardest part is marking the wall. I used a piece of cardboard that was the same size as the towel warmer. Then I put the two machine-screws into the top mounting holes on the towel warmer. I carefully placed the warmer on top of the cardboard with the screws against the cardboard and gently pushed the warmer to mark the top. mounting holes. Then I pushed the warmer, very carefully, where the two plastic electrical caps were and again marked the cardboard for the bottom mounting holes. Then I just centered the cardboard on the wall, where I wanted to mount the warmer. Using a sharp point drift pin; I pushed the drift pin through the cardboard and made marks on the wall for all four mounting holes. I used a 1/4” drill bit for the three plastic anchors. And because I hard wired the warmer, I used a1/2” drill bit to run the wire into the wall. All the mounting hardware is also good quality and strong. Because I hard wired mine, I mounted three of the spacers without the wire onto the warmer. And the fourth spacer, with the wire, I attached to the wall. Then I was able connect the electrical connector, install all the set screws.The unit heats up in 5 to 10 minutes and does a nice job of warming the towel. The unit gets hot to the touch but cools off quickly when you turn it off. I am very happy with the operation and quality of this item!

Love it

Easy to install and work great