Customer Reviews for VEVOR Pallet Forks, 2000 lbs Clamp on Pallet Forks, 43" Total Length Tractor Bucket Forks with Adjustable Stabilizer bar, Heavy Duty Pallet Forks for Tractor Attachments, Skid Steer, Loader Bucket

Picking up logs hauling them holds a good amount.

The forks are built very sturdy, but the spreader bar was junk. It was way too light of material. Bent all up first use. The forks are worth every penny.

I bought these expecting to not like them at all, but if I could get one job done with them it would be worth it. The attached to the tractor bucket easily, but I could tell that the connection wasn't solid. I used a boxed end wrench to get a little more torque on the handle and immediately bent the attachment point. So I cut off the original hardware, drilled out the holes and added 3/4 inch grade 8 bolts to beef it up. Now they work great. Even with needing to modify I would buy again. Would give this 5 stars if they upgrade the hardware and keep the price the same.

I would have liked a lock down on both tines.

Everything works as it should the wing bolts appear to be sturdy and should last a long time. Overall very pleased. I use this product on a 35hp newholland front end loader to pick up logs to cut them with chainsaw for fire wood.

This product worked well on my Kubota B21. My only complaint is that one of the forks does not tighten down as much as the other. I shimmed it so it still works. The threaded rods to clamp to the bucket should be just a hair longer.

Upon delivery I inspected the fork lifts and the found the workmanship to be excellent. The welding and painting was of high quality. The design can only be described as ROBUST! The crossbar is must have. It's adjustable to the width you require and steadies the forks. I can't imagine using the forks without the crossbar installed.No instructions arrived with the product. However, if you require written instructions to install them you probably shouldn't be operating a tractor. These are very simple clamp on devices.The backs of the forks have slots so a couple pieces of lumber can be cut to 2 1/2" x 1 5/8" and slipped in to provide a Load Backrest. The backrest will prevent the load from tipping backwards onto the tractor. The backs of the forks also have key ways that can be used for hanging them on a shop or shed wall. Just screw a couple 1/2" lag bolts into studs and slip the fork lift key ways over the bolts. By installing a bicycle hook to a stud you can also hang the stabilizing cross bar(s). They're out of the way and easy to locate when you need them.As for operation - they're different than an actual forklift that utilizes a vertical mast and rotating lift. The tractor uses its loader to perform both functions. Be slow and patient as you move the tractor's loader control.I used the the fork lift to pick-up and move tree trunks that I had cut down and delimbed to a sawbuck. I had to cut the trees down to 15 to 20 feet so they were easy to maneuver with the tractor. The fork lift easily lifted the tree trunk. I unloaded the tree trunk by tipping the loader and allowing gravity to drop it into the sawbuck. I'm not sure I could do this every time but I did it twice. After cutting the trunk into 16" logs I was able to toss the logs into the loader and haul them to my wood pile.These fork lifts saved a lot of time. Without them I would have had to cut the tree into 5' lengths and pick them up by hand or roll them into my tractors loader. Once I moved them to the

Good price, well built, easy to attach. spacer bar is a good feature.

Although it took two tries to get the product delivered, it did finally arrive. To date, I have only used it once, but it seems to do what I intended. I like the fact that the space between the forks can be adjusted and locked in. I seems to be heavy enough to allow me to do anything I need to do.

Works great