Customer Reviews for VEVOR Truck Bed Extender, Aluminum Retractable Tailgate Extender, 55.5"-68", Fits for Ford Super Duty, F150, Dodge Ram 1500/2500/3500, Toyota Tundra, Nissan Titan, Chevrolet Silverado, GMC Sierra

Easy installation, if you understand Chinese. A bag with screws and bolts I done need. Part K was never mentioned in the instructions. Its all together, but one problem. The connectors where it fits into the brackets don't match the same direction. One side of each post has a flat side for the locking pin but both are not facing the same direction. I can get the locking pin in on one side but not the other. if the seller or manufacturer wants to send only 2 mounting ends that match directions, I'd be thrilled. Reasonably priced.

Just a couple screws and the alignment guide worked perfectly. Used this extender a few times already to get material from home improvement stores and it's great since we got the shorter Tundra bed length.

I didn’t use the large spacer that came with the kit to clear the bed cover. I used a smaller block I had laying around the garage. Limited man skills required to assemble and instal in about 30 minutes or so.

However, if you have a hard bed cover with lever type clamps, the extender will interfere with the rear clamps.

I'll start by saying that this was installed in my 24 Maverick Hybrid. Outside that, I have no knowledge. Everything went pretty well with the install. The extender fit without any mods to the size. I will warn you. Getting the nuts and washers on the bolts through the taillight holes is challenging. Also, creating the holes through the drop in bedliner to match the pre-drilled ones in the truck bed sheet metal wasn't easy. The design of the device (cutting length) allows for some modification if your heart desires but I tried to minimize that. I did add washers between the provided bolts and locknuts. As the width was reduced to pretty much the minimum allowable without cutting metal, I only used one of the two provided supports and centered it. I could've used 2 but they would have been very close to one another. I would say from opening the box to being done with all my crap put away, it took about 4 hours. Probably 90 minutes of that was consumed with drilling through the bed liner and securing the bolts to hold the latches. I am slow. It feels sturdy enough to me and I'm a bit OC. In comparison with other choices on Amazon, this one came out on top in balancing price and reviews. I should really write a disclaimer to attach to my reviews. I don't rate something as 5 stars if it meets expectations. It seems that alot of people do though. For me 3 stars is meeting expectations, 4 is better than expected, and 5 is a real stand-out. You can figure out how it would go the other way from that.

The very first time I used this product it went together perfectly we put it on and the very first time I took it off, broke the little plastic pieces on part number C, the pivot upright assembly. In my opinion they should be made out of metal. I am wondering if they make parts for this product. Otherwise, it’s five stars across-the-board

I was a little concerned at first that this wouldn't fit my Maverick pickup. When assembling I managed to get the system to collapse into a position that was slightly less wide and it fit perfectly.

Easy to assemble. Great construction.

Perfect fit, easy to install.

I have a Santa Cruz and it's a real tight fit. The screws didn't fit they were too small. I like the item, but it's just a little Too big for the Santa Cruz.