Customer Reviews for VEVOR Welding Table 36 x 24-inch, 600LBS Load Capacity Steel Welding Workbench Table on Wheels, Portable Work Bench with Double-Layer Storage Board, 5/8-inch Fixture Holes, 11 Hooks

Well the box had a few holes in it, but all the parts were wrapped in a bag with straps & packed well.... Vevor you still need a better box?? The top came oiled & wrapped with paper no rust & each part was wrapped , no paint damaged... everyone talks about the wheels & I'm to old to get on the floor & adjust them , got lucky & found two 6x6, just slide them under & rock solid... HF chair & just the right height to set & weld.... The table top is 40x24... well that's all folks...later...Sandman......

Just wish was little bigger but over all work great holding up to all thr job and hold the weight I seat on top ans love the under table

The item is great for the price, but the package wasn't the best it came with some paint damaged I called customer service and they discounted 20.00.

Sturdy and stable. I assembled in my living room, then wheeled out to the garage.

The table is heavier and sturdier than I thought and should be ok for the occasional welding I do. The only problem is the packaging is not sufficient to prevent damage during shipment. The table arrived with one of the casters broken and the bottom shelf dented where the caster was located in the box. I called customer service, and they sent me a new caster within a few days. The dent was minor, so I let it pass.

Great table! No non-sense just good quality and functional. Welding table VEVOR Welding Table 36'' x 24'' is just as described. Look no further. Just buy it.

The welding table is great. The packaging is not. The table arrived in a battered box with no screws and only two wheels. If they improved the packaging it would be great

Make sure you're reading the correct reviews. When I looked at the Vevor page for this table, all the reviews were for a different item (folding table with Yellow legs). This is the fixed (but adjustable) fixture table with grey/black legs. For the price you can't go wrong, it would cost you more for the materials to build this. Mine arrived with one corner dented so maybe a little more packaging would be helpful. I was able to bang the dent out and it won't affect my use. As other reviews have stated, the quality of the bolts could be better and some washers would probably help. They claim it can hold 600# but I wouldn't go near it with something that heavy on it. I couldn't fit the little canvas gloves on my hands but I didn't buy it for the gloves. I'm still not sure what all of the "fixture" tools are supposed to be but I didn't buy it for those, or the cheap clamps either. All in all a great bargain for the price and just what I needed. My only advice to them would be to skip all the accessories and use the savings to improve the packaging and assembly hardware. That's what people are buying it for.

This nifty table folds up and hides behind my welding cart. It will take a minute to put this together, but the instructions were adequate enough for me to only have to undue one mistake because I thought I knew what I was doing. I won't be using the table as a work table or to hold a large amount of weight (such as a large jeep bumper) without some modification to make sure the top does not slide over, but for the price and the smaller stuff I will be doing it will work well.

Strong steel construction. I added washers under the bolt heads, although it is probably fine without them. The holes in the table are slightly undersize (0.622"), probably because they were punched (not drilled) with the 3 mm steel plate hot. I had to turn down the shanks slightly on my clamps to fit in. (That is not a big deal, but I am not about to try to drill out all of the table holes.) The lower shelf is really useful and the casters roll nicely.