VEVOR Sand Anchor, 36" Length Auger to The Beach and Sandbar, 316 Stainless Steel Screw Anchor w/Removable Handle, Bungee Line & Carry Bag, for Jet Ski PWC Pontoon Kayak

Worked well even in a strong tide. Also comes in a knife storage bag.we’ll see how it holds up. Nice polished stainless finish

The actual stainless anchor itself is great, but a few things need improvement: 1. The grips are a cheap foam and fail quickly. I would much rather have a harder material that lasts than cheap foam that splits and fails quickly, but all-in-all it's not going to prevent you from using the anchors. 2. The storage bags are cheap. One arrived with a hole in it and the other failed right behind it. This is a safety concern in my opinion because the anchor rip through the bottom of the bag and stab someone's foot. This needs to be addressed ASAP. 3. Only 1 carabiner included per anchor. This is problematic because not all boats have cleats or something that you can loop the non-carabiner end onto. It would be nice if more were included, but that's not going to happen so I would recommend buying a couple if you think you'll need them. 4. Be mindful when anchoring at sandbars where water is deeper than 36". If you anchor it before you attach the bungee and walk away from it, there's a good chance you'll lose it and have to walk around until you run into it. Also, be sure to anchor it away from where people might be jumping or playing in the water so they don't land on it. All that to say, it would be nice if these were coated with a bright orange powder coat or something comparable for hi-visibility. Do they work? Yes they do, usually. If you're in water where there might be regular wake and you have a larger heavier boat, make sure you anchor them very deep, especially in softer sands (takes a while). The boat will pull these right out of the ground and it'll be going for a ride (even when they're pretty deep). I initially bought these thinking they'd hold the boat better than a standard anchor and they do to an extent, but it's all conditional. Think about where you like to anchor normally, think about the depth of the water (are you going to be under water installing them?), think about how much wake is in the area, how heavy is your boat, etc. Do I like them? Yes, but a standard anchor is much easier to adjust and reposition a boat when it does move. When these pull out of the ground, it's a whole ordeal. You have to disconnect it from the boat and reset it (boat is just floating away), so take the extra time to install them deeper than you'd think you'd need them to be. That brings me to my final request: 5. Make the corkscrew blade diameter larger for stronger hold. Thanks for reading!

Works great love it!

I think using this will be easier and stronger than throwing out an anchor on sandbar. Finish on this was surprisingly nice-polished. A nice addition would be to provide a stainless steel aircraft cable tether to the handle that detaches to twist it down with. It will get separated so I will make up my own and drill a hole through center of the handle pin. Very happy with this and all my other vevor purchases.

It holds my paddle boat facing the water.

We ordered 2 of these and they are fantastic! We ordered another 2 for our friends. 1 of the poles came in bent.

It is fit for my machine and works good.

We use it for our boat and it was nice since we boought it, no prblems.

After receiving the package and found it damaged, I immediately contacted customer service to deal with it. I am very satisfied.

The quality is good, and it has been used for a long time without any problems. Good reviews.